How to Repair Low Pressure in a Kitchen Faucet Consumer Reports

Faucets are one of the essential accessories found in the kitchen. It is a device that is used to carry out day-to-day activities in the kitchen. Apart from the fact that it supplies gallons of water or cooking and washing dishes in the kitchen, it also produces water use in the bathroom and other places where water is need.

However, his accessory is faced with one major issue or problem known as low pressure. Low pressure is a situation where the amount of water that is delivered to the sink is small to the average rate. Fortunately, you can fix this problem within a short time and without spending a lot of cash.

This article has been written to help you with how to repair low pressure in a kitchen faucet. While doing this, it will also look into the causes of low pressure in a kitchen faucet.

As said earlier, fixing the problem with your kitchen faucet is easy and can be done within a limited time. Hence, before this could be achieved, you must know the cause of the low pressure. If this problem affects other outlets in your home, then you should know that the problem is not directly from the kitchen but the source.

Thus, if later discovered that the low-pressure issue affects the whole house, the first step you should take is to check with the neighbours to determine if they also experience the same issue with you. Thus, if the problem only affects your kitchen faucet, the steps to repair it is explained below.

How to Repair Low Pressure in a Kitchen Faucet

Before preparing to repair low pressure with your kitchen faucet, it is essential to know that this problem is most of the time caused by a blockage in the aerator or an obstruction in the cartridge. The aerator is an element that functions as a restrictor, and it is used to reduce the water flow by adding air. A blocked aerator is known to be the most common issue that affects faucets. Fortunately, it is one of the easiest to solve.

The first thing you will do when repairing a blocked aerator is to remove the aerator from the faucet. You can do this by using your hands to unscrew it. However, if you are unable to do this successfully, then you might need a pair of pliers. If you are still finding it difficult to remove the aerator, you may have to try to remove any clogging with aerator still in place.

After pulling off the aerator, you then soak it in a dish of vinegar and warm water for about 6o minutes or more. If the aerator is still blocked, then you might need to get a commercial lime or replace it immediately. Having removed the aerator, a test on the faucet should be conducted to see if the problem has been found or not. If you are still experiencing low pressure, it means the issue is down the waterway, and you would need the service of a plumber. You might not need a plumber if you don’t experience any low pressure with the faucet again. All you need to do now is to get the aerator clean and fix it back again.

The cartridges are elements with small holes which can sometimes get blocked with debris. In other to repair this, here are the steps to follow:

The first thing you need to do is to turn off the water supply and put on the faucet to allow all the water to escape out of the outlet. Then, you remove the screw cap with a screwdriver removes the screw that fastens down the faucet with an Allen wrench.

After that, you detach the cartridge nut under the faucet. While doing so, you must place the pieces that are in the faucet orderly in a safe place to fix them back easily.

You then remove the cartridge out and clean it with a neat and warm running water. If you still see any buildup of limescale after washing the cartridge, then you might need to soak it in vinegar to remove the debris or replace it with a new one. All you need to do now is to place the cleaned cartridge back into the faucet, and your kitchen faucet is ready to work.